EICON TECHNOLOGY CORPORATION
DIVA T/A ISDN MODEM
Card Type |
ISDN Modem |
NIC Type |
ISDN |
Maximum Onboard Memory |
4KB |
Boot ROM |
Unavailable |
Network Transfer Rate |
230.4Kbps |
Topology |
Star |
Wiring Type |
RJ-45 ISDN BRI |
Data Bus |
External |
CONNECTIONS | |||
Function |
Label |
Function |
Label |
25-pin DTE serial port |
CN1 |
RJ-11 analog phone interface |
PH1 |
Power connector |
CN2 |
RJ-11 analog phone interface |
PH2 |
RJ-45 ISDN interface |
ISDN |
USER CONFIGURABLE SETTINGS | ||
Setting |
Label |
Position |
Resistance set to 100Ohm (connection span >75meters) |
SW1 |
On |
Resistance set to 50Ohm (connection span <75meters) |
SW1 |
Off |
Note: Switch available on S/T models for Australia only. Termination requirements vary according to the number of devices connected to the NT1, and the distance between devices and NT1. |
DIAGNOSTIC LED(S) | |||
LED |
Color |
Status |
Condition |
B1 |
Unidentified |
On |
B-channel 1 connection is good |
B1 |
Unidentified |
Blinking |
B-channel 1 connection is being established |
B1 |
Unidentified |
Off |
B-channel 1 connection is broken |
B2 |
Unidentified |
On |
B-channel 2 connection is good |
B2 |
Unidentified |
Blinking |
B-channel 2 connection is being established |
B2 |
Unidentified |
Off |
B-channel 2 connection is broken |
DT |
Unidentified |
On |
ISDN interface is established. Data transmission is possible |
DT |
Unidentified |
Blinking |
ISDN interface is initializing or error is occurring. Data transmission is not possible |
DT |
Unidentified |
Off |
ISDN interface is not activated |
LNK |
Unidentified |
On |
ISDN link is good |
LNK |
Unidentified |
Blinking |
ISDN link is synchronizing |
LNK |
Unidentified |
Off |
ISDN link is broken (In Europe this indicates idle status) |
P1 |
Unidentified |
On |
Connection is good on voice channel 1 |
P1 |
Unidentified |
Blinking |
Outgoing or incoming connection is being established on voice channel 1 |
P1 |
Unidentified |
Off |
No activity on voice channel 1 |
P2 |
Unidentified |
On |
Connection is good on voice channel 2 |
P2 |
Unidentified |
Blinking |
Outgoing or incoming connection is being established on voice channel 2 |
P2 |
Unidentified |
Off |
No activity on voice channel 2 |
TX-RX |
Unidentified |
Blinking |
Data is being transmitted/received on serial port |
TX-RX |
Unidentified |
Off |
Data is not being transmitted/received on serial port |
DTE |
Unidentified |
On |
Serial port connection is good |
DTE |
Unidentified |
Blinking |
Serial port connection is being established |
DTE |
Unidentified |
Off |
Serial port connection is broken |
FAULT |
Unidentified |
On |
Software fault condition detected |
FAULT |
Unidentified |
Blinking |
Hardware fault condition detected |
FAULT |
Unidentified |
Off |
ISDN modem is operating normally |
PWR |
Unidentified |
On |
Power is on |
PWR |
Unidentified |
Off |
Power is off |