Card Type	Fax, Modem (asynchronous)
Chip Set	Unidentified
Maximum Data Rate	33.6Kbps
Maximum Fax Rate	14.4Kbps
Data Bus	PCMCIA Type II
Fax Class	Class I & II
Data Modulation Protocol	Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34
Fax Modulation Protocol	ITU-T V.17, V.21CH2, V.27ter, V.29
Error Correction/Compression	MNP5, V.42, V.42bis

SUPPORTED COMMAND SET

Basic AT Commands

AT, A/

A, E, H, V, W, Z

&D, &F, &W

S Registers

S0, S6, S7, S8

Note: Please see MHI Help file for full command documentation.

DIAL
Type:	Immediate
Format:	AT [cmds] D<#> [cmds]
Description:	Dials telephone number according to any modifiers included in the string
Note:	Any combination of modifiers can be used to produce the desired dial functions in sequence.
Modifier	Function
T	Tone dialing enabled
P	Pulse dialing enabled
,	Dialing paused for amount of time specified in S8 register
W	Dialing resumed following dial tone detection

SPEAKER VOLUME
Type:	Configuration
Format:	AT [cmds] Ln [cmds]
Description:	Controls speaker volume
Command	Function
L0	Speaker volume disabled
í L2	Speaker volume enabled

SPEAKER MODE
Type:	Configuration
Format:	AT [cmds] Mn [cmds]
Description:	Selects various speaker options
Command	Function
M0	Speaker disabled
í M1	Speaker enabled until carrier signal detected, off for transmission
M2	Speaker enabled

DATA CARRIER DETECT (DCD)
Type:	Configuration
Format:	AT [cmds] &Cn [cmds]
Description:	Selects whether the DCD option is enabled or disabled
Command	Function
&C1	DCD enabled after carrier signal detected

MISCELLANEOUS TECHNICAL NOTES

The PCMCIA fax/modem requires an analog RJ-11 telephone line. A PBX or digital phone line may damage the PCMCIA fax/modem or telephone equipment.