Card Type	Fax, Modem (synchronous/asynchronous), Network Interface Card
Chip Set	Unidentified
I/O Options	Ethernet 10BaseT connector, Ethernet 10Base2 connector
NIC Type	Ethernet
Network Transfer Rate	100Mbps
Maximum Modem Rate	28.8Kbps
Maximum Fax Rate	14.4Kbps
Data Bus	PCMCIA Type II
Fax Class	Class I & II
Data Modulation Protocol	Bell 103/212A ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.34
Fax Modulation Protocol	ITU-T V.17, V.21CH2, V.27ter, V.29
Error Correction/Compression	MNP5, V.42, V.42bis
Topology	Linear Bus, Star, Ring
Wiring Type	Unshielded twisted pair RG-58A/U 50ohm coaxial
Boot ROM	Not available

CONNECTIONS
Function		Label		Function		Label
RJ-45 UTP/10BaseT	CN1		RG-58A coaxial/10Base2		CN2

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
TX/RX	Green	Blinking	Transmitting/receiving data to/from network
TX/RX	Green	Off	Not transmitting/receiving data to/from network
LINK	Green	On	Link integrity good on 10BaseT network
LINK	Green	Off	Link integrity broken on 10BaseT network

SUPPORTED COMMAND SET

Basic AT Commands

AT, ‘+++’, ‘Comma’, A/

A, D, E, H, L, M, V, W, Z

&C, &D, &F, &W, &X, &Y, &Z

S Registers

S0, S6, S7, S8

Note: See MHI Help file for full command documentation.