HwMuseum | Index

TRANSITION ENGINEERING, INC.

E-TBT-CHB-2012-M/E-TBT-CHB-2012-S

NIC Type:

Ethernet

Transfer Rate:

10Mbps

Data Bus:

16-bit ISA

Topology:

Star

Wiring Type

AUI transceiver via 50-pin port

Boot ROM

Not available

INTERRUPT SELECTION

Setting

J1

»

IRQ is software configured

Pins 2 & 3 closed

 

IRQ5

Pins 1 & 2 closed

CARD NUMBER

Card Number

SW1/1

SW1/2

SW1/3

SW1/4

»

#0

On

On

On

On

 

#1

On

On

On

Off

 

#2

On

On

Off

On

 

#3

On

On

Off

Off

 

#4

On

Off

On

On

 

#5

On

Off

On

Off

 

#6

On

Off

Off

On

 

#7

On

Off

Off

Off

 

Note (1):SW1 is not installed on the HubServer card. The default setting for the HubServer card is #0.

Note (2):The default setting for Expansion Hub cards is #1. If no HubServer card is used, the first Expansion Hub card should be set to #0. All daisy-chained Expansion Hub cards must be sequentially numbered starting at #1.

CONNECTORS

Purpose

Location

Expansion card daisy-chain connector

CN6

Expansion card daisy-chain connector

CN7

Note (1):The first card of a cluster, usually the HubServer card, must have a termination plug installed on CN7.

Note (2):The last card of a cluster must have a termination plug installed on CN6.