NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	32-bit EISA
Topology	Star Linear Bus
Wiring Type	RG58A/U 50ohm coaxial Shielded/Unshielded twisted pair AUI transceiver via DB-15 port
Boot ROM	Available

ACTIVITY LED ENABLE
Setting		JP1
»	Disabled	Pins 1 & 2 closed
	Enabled	Pins 2 & 3 closed
Note:If the network hub has an activity LED for each line, setting this option to enabled will allow the hub LED to operate properly

CABLE TYPE
Type		JP6
»	Software select	Pins 1 & 2 closed
	RG58A/U 50ohm coaxial	Pins 2 & 3 closed

ONBOARD TERMINATOR
Setting		JP7
»	Disabled	Pins 2 & 3 closed
	Enabled	Pins 1 & 2 closed
Note:When using RG58A/U 50ohm coaxial cable the onboard 50ohm terminator may be used instead of using a T-connector and an external terminator.

DIAGNOSTIC LED(S)
LED	Status	Condition
LED1	On	Data is being transmitted
LED1	Off	Data is not being transmitted
LED2	On	Twisted pair connection is good
LED2	Off	Twisted pair connection is broken
LED3	On	Data is being received
LED3	Off	Data is not being received
LED4	On	Collision detected on network
LED4	Off	No collisions detected on network

FACTORY CONFIGURED SETTINGS
Jumper	Setting
JP2	Unused
JP3	Unused
JP4	Unused
JP5	Unused