5210E, LE031-C

HwMuseum | Index BLACK BOX CORPORATION

5210E, LE031-C

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Available

INTERRUPT REQUEST
IRQ		JP1	JP2	JP3	JP4	JP5	JP6
»	2	Closed	Open	Open	Open	Open	Open
	3	Open	Closed	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Open	Closed	Open
	7	Open	Open	Open	Open	Open	Closed

I/O BASE ADDRESS
Address		JP7	JP8	JP9	JP10	JP11	JP12
	200h	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3
	208h	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2
	210h	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3
	218h	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
	350h	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3
	358h	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2
»	360h	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3
	368h	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2
	370h	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3
	3E0h	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3	Pins 2 & 3
	3E8h	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2
	3F0h	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 2 & 3
	3F8h	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2	Pins 1 & 2
Note: Pins designated should be in the closed position. A full range of I/O addresses are available, in increments of 8h, from 200h to 3F0h for a total of 64 addresses. The 12 examples given are taken from the beginning (first four), the middle (middle four), and the end (last four) of the 64 addresses. To figure out the correct configuration for the I/O address you wish to use, subtract 200h from the address, divide the remainder by 08h, and convert the quotient to a 6-digit binary number. The binary number will represent the setting of each jumper. Each 0 represents pins 2 & 3 closed while each 1 represents pins 1 & 2 Closed. JP7 is the most significant bit (MSB) and JP12 is the least significant bit (LSB). For example, If the desired address is 228h; 228h - 200h = 28h, 28h /08h = 05h, 05h = 000101b, then the setting should be:
	Address	JP7	JP8	JP9	JP10	JP11	JP12
	228h	Pins 2 & 3	Pins 2 & 3	Pins 2 & 3	Pins 1 & 2	Pins 2 & 3	Pins 1 & 2

BASE MEMORY ADDRESS
Address		JP13	JP14	JP15	JP16
»	C0000h	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed
	C4000h	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
	C8000h	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
	CC000h	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed
	D0000h	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed
	D4000h	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
	D8000h	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
	DC000h	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed
	E0000h	Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed
	E4000h	Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed
	E8000h	Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 2 & 3 Closed
	EC000h	Pins 1 & 2 Closed	Pins 2 & 3 Closed	Pins 1 & 2 Closed	Pins 1 & 2 Closed

EXPANSION MEMORY /BOOT ROM CONFIGURATION
Size		JP17	JP18
»	None	Pins 1 & 2 Closed	N/A
	8KB RAM	Pins 2 & 3 Closed	Pins 2 & 3 Closed
	Boot ROM	Pins 2 & 3 Closed	Pins 1 & 2 Closed
Note:The socket on the diagram labeled RAM/ROM can hold either a boot ROM chip or another 8KB RAM chip

CABLE TYPE
Type		W2 - W8
»	RG-58A/U 50ohm coaxial	2nd Setting
	AUI transceiver via DB-15 port	1st Setting
Note:Refer to the diagram for the meanings of 2nd setting & 1st setting.

DATA BUS CONFIGURATION
Setting		WR27
»	Any slot other than slot 8 on a PC/XT	Open
	Slot 8 on a PC/XT	Closed
Note:If installing this card in slot 8 of a PC/XT, you must close JP27. If card is not installed in a PC/XT or