Card Type	Data Aquisition
Chip Set	Unidentified
Maximum Onboard Memory	Unidentified
I/O Options	Analog input, digital input
Hard Drives supported	None
Floppy drives supported	None
Data Bus	16-bit ISA
Card Size	Full-length

CONNECTIONS
Function	Label	Function	Label
40-pin header to 37-pin analog/digital signals connector via cable	J1	DAC1 bipolar offset selector	P5
40-pin header to 37-pin analog/digital signals connector via cable	J2	DAC1 range selector	P6
50-pin analog/digital signals connector	J8	A/D converter unipolar offset selector	P7
DAC0 unipolar offset selector	P1	A/D converter bipolar offset selector	P8
DAC0 bipolar offset selector	P2	A/D converter unipolar range selector	P9
DACO range selector	P3	A/D converter bipolar range selector	P10
DAC1 unipolar offset selector	P4	A/D converter zero selector	P11

ANALOG INPUT RANGE CONFIGURATION
Polarity		Range	JP1	JP2
»	Bipolar	-10V to +10V	Pins 1 & 2	Pins 1 & 2
	Unipolar	0V to +10V	Pins 2 & 3	Pins 2 & 3

BASE I/O ADDRESS SELECTION
Setting		SW1/1	SW1/2	SW1/3	SW1/4	SW1/5
	000h	Off	Off	Off	Off	Off
	020h	Off	Off	Off	Off	On
	040h	Off	Off	Off	On	Off
	060h	Off	Off	Off	On	On
	080h	Off	Off	On	Off	Off
»	120h	Off	On	Off	Off	On
	360h	On	On	Off	On	On
	380h	On	On	On	Off	Off
	3A0h	On	On	On	Off	On
	3C0h	On	On	On	On	Off
	3E0h	On	On	On	On	On
Note: A total of 32 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/1 is the Most Significant Bit and jumper SW1/5 is the Least Significant Bit. The jumpers have the following decimal values: SW1/1=512, SW1/2=256, SW1/3=128, SW1/4=64, SW1/5=32. Turn off the switches and add the values of the switches to obtain the correct memory address. (On=1, 0ff=0)