DISTRIBUTED PROCESSING TECHNOLOGY
PM2022
|
| |
|
Data bus: |
32-bit EISA |
|
Size: |
Three-quarter length, Full-height card |
|
Hard drive supported: |
Up to seven SCSI devices |
|
Floppy drives supported: |
360KB, 720KB, 1.2MB, 1.44MB |
CM 4000 Module
|
CONNECTIONS | |
|
Function |
Location |
|
58-pin CM4000 expansion connector |
J1 |
|
58-pin CM4000 expansion connector |
J2 |
|
50-pin SCSI interface - external |
J11 |
|
10-piece LED |
LED(s) |
|
58-pin CM4000 expansion connector |
P1 |
|
58-pin CM4000 expansion connector |
P2 |
|
6-pin DM4000 expansion connector |
P5 |
|
4-pin connector - drive active LED |
P6 |
|
3-pin DM4000 expansion connector |
P7 |
|
34-pin control cable connector - floppy drive |
P8 |
|
50-pin SCSI interface - internal |
P10 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Floppy drive interface enabled |
Y20 |
closed |
|
Floppy drive interface disabled |
Y20 |
open | |
| » |
TERMPWR enabled |
Y50 |
closed |
|
TERMPWR disabled |
Y50 |
open | |
|
DIAGNOSTIC LED(S) | ||
|
LED |
Status |
Condition |
|
1-10 |
Blinking in rotating pattern |
SCSI activity has ceased |
|
1-8 |
Blinking quickly in rotating pattern |
EISA adapter has not been configured |
|
9 |
on |
IRQ is pending |
|
1-4 |
Blink once per second at power-up |
Trap error in processor |
|
1, 2, & 8 |
Blink once per second at power-up |
No SIMM in socket 1 of CM4000 |
|
2 & 8 |
Blink once per second at power-up |
Largest SIMM is not in socket 1 of CM4000 |
|
3 & 8 |
Blink once per second at power-up |
Parity SIMM is not in socket 1 |
|
Other combination |
Blink once per second at power-up |
Firmware trap has occurred |
|
DS1 |
on |
Fault has occurred with CM4000 module |
|
DS1 |
off |
No fault has occurred |
|
DS2 |
on |
ECC enabled |
|
DS2 |
off |
ECC disabled |
|
MISCELLANEOUS TECHNICAL NOTES |
|
Note: The manufacturer does not provide a diagram of the DM 4000 module. |