DATA TECHNOLOGY CORPORATION
DTC5180C REV. G
|
| |
|
Data bus: |
16-bit, ISA |
|
Size: |
Half-length, full-height card |
|
Hard drive supported: |
Two MFM ST506/412 drives |
|
Floppy drives supported: |
None |
|
CONNECTIONS | |
|
Function |
Location |
|
34-pin control cable connector - hard drive |
J1 |
|
20-pin data cable connector-drive 0 |
J2 |
|
20-pin data cable connector-drive 1 |
J3 |
|
4-pin connector-Drive active LED |
J4 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Floppy drive change not driven |
W1 |
open |
|
Floppy drive change signal driven low |
W1 |
closed | |
| » |
Hard drive port address is 3F6, 3F7, 1F0-1F7h |
W4 & W5 |
open |
|
Hard drive port address is 376, 377, 170-177h |
W4 & W5 |
closed | |
|
HARDWARE/FIRMWARE DRIVE SELECT MODE ENABLE | |||
|
Function |
W2 & W3/jumper 1 |
W2 & W3/jumper 2 |
W6 |
|
Hardware mode |
closed |
open |
closed |
|
Firmware mode |
open |
closed |
open |