ACCULOGIC, INC.
VESAPPORT
|
Data bus: |
32-bit VL-bus |
|
Size: |
Three-quarter length, full-height card |
|
Hard drive supported: |
Up to seven Fast SCSI-2 devices, up to fifteen Fast and Wide SCSI-3 devices |
|
Floppy drives supported: |
Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives |
|
CONNECTIONS | |
|
Function |
Location |
|
34-pin cable connector - floppy drive |
J3 |
|
4-pin connector - drive active LED |
J4 |
|
50-pin SCSI connector - internal |
J5 |
|
50-pin SCSI connector - external |
J6 |
|
68-pin SCSI connector - internal |
J10 |
|
Power connector |
JP8 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
» |
Floppy drive interface enabled as primary |
JP2 |
Pins 2 & 3 closed |
|
|
Floppy drive interface disabled |
JP2 |
Pins 1 & 2 closed |
|
» |
Normally configure board during installation |
SW1 |
Position 2 |
|
|
Lock configuration during installation |
SW1 |
Position 1 |
|
|
Reset configuration |
SW1 |
Position 3 |
|
Note: SW1 is set to normal unless two ISApport boards are installed on the same system. In this situation, the boards are installed sequentially. First, board 1 is installed and configured. Then, its SW1 is set to lock, and board 2 is installed and configured with its SW1 set to normal. The reset setting for SW1 is unidentified. | |||
|
MISCELLANEOUS TECHNICAL NOTES |
|
VESApport can only be configured with devices chained off two SCSI connectors (e.g. J5 and J6, J5 and J10, or J6 and J10). The board does not work when devices are chained off all three connectors. |