ACCULOGIC, INC.
SIDE-3/PLUS (REV.2)
|
| |
|
Data bus: |
16-bit ISA |
|
Size: |
Half-length, full-height card |
|
Hard drive supported: |
Two IDE(AT) drives |
|
Floppy drives supported: |
Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives |
|
CONNECTIONS | |
|
Function |
Location |
|
4-pin connector - drive active LED |
J1 |
|
40-pin primary IDE(AT) connector |
J2 |
|
34-pin cable connector - floppy drive |
J3 |
|
Optional drive power connector |
J4 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Floppy drive interface enabled |
JP6 |
Open |
|
Floppy drive interface disabled |
JP6 |
Closed | |
| » |
IDE(AT) interface enabled |
JP7 |
Open |
|
IDE(AT) interface disabled |
JP7 |
Closed | |
| » |
Single speed floppy drives supported |
JP8 |
Open |
|
Dual speed floppy drives supported |
JP8 |
Closed | |
| » |
Floppy drive precompensation is 125 ns |
JP9 |
Open |
|
Floppy drive precompensation is 187 ns |
JP9 |
Closed | |
| » |
IOCHRDY signal disabled |
JP10 |
Open |
|
IOCHRDY signal enabled |
JP10 |
Closed | |
|
USER CONFIGURABLE SETTINGS (CONTINUED) | |||
|
Function |
Location |
Setting | |
| » |
On-board BIOS ROM enabled |
JP11 |
Open |
|
On-board BIOS ROM disabled |
JP11 |
Closed | |
| » |
Primary floppy is any type other than 2.88 MB |
JP14 |
Open |
|
Primary floppy is 2.88 MB drive |
JP14 |
Closed | |
| » |
Secondary floppy is any type other than 2.88 MB |
JP15 |
Open |
|
Secondary floppy is 2.88 MB drive |
JP15 |
Closed | |
|
INTERRUPT TIMING SELECTION | |||
|
Timing |
JP1 |
JP2 | |
| » |
Normal |
Closed |
Open |
|
Delayed until ACTIVE-signal is removed |
Open |
Closed | |
|
BIOS ADDRESS SELECTION | |||
|
Address |
JP12 |
JP13 | |
| » |
C8000-CBFFFh |
Open |
Open |
|
CC000-CFFFFh |
Open |
Closed | |
|
D8000-DBFFFh |
Closed |
Open | |
|
DC000-DFFFFh |
Closed |
Closed | |