Data bus:	16-bit ISA
Size:	Half-length, full-height card
Hard drive supported:	Two IDE(AT) drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
40-pin IDE(AT) connector	J1
34-pin cable connector - floppy drive	J5
10-pin serial port 2 - internal	CN1
9-pin serial port 1 - external	CN2
25-pin parallel port - external	CN3
2-pin connector - drive active LED	CN5

USER CONFIGURABLE SETTINGS
Function	Location	Setting
IOCHRDY signal disabled	J2	open
IOCHRDY signal enabled	J2	closed
Floppy transfer rate is 300 KB/s	J3	closed
Floppy transfer rate is 250 KB/s	J3	open
Floppy drive interface enabled	J4	closed
Floppy drive interface disabled	J4	open
Parallel port address is 278h	J6	pins 1 & 2 closed
Parallel port address is 378h	J6	pins 2 & 3 closed

USER CONFIGURABLE SETTINGS CONTINUED
Function	Location	Setting
Serial Port I address is 3E8h	J7	pins 1 & 2 closed
Serial Port I address is 3F8h	J7	pins 2 & 3 closed
Serial Port I disabled	J7	open
Serial Port 2 address is 2E8h	J8	pins 1 & 2 closed
Serial Port 2 address is 2F8h	J8	pins 2 & 3 closed
Serial Port 2 disabled	J8	open
IDE(AT) interface enabled	J9	pins 1 & 2 closed
IDE(AT) interface disabled	J9	pins 2 & 3 closed
Parallel port IRQ 7 select	J10	pins 2 & 3 closed
Parallel port IRQ 5 select	J10	pins 1 & 2 closed