AUVA COMPUTER, INC.
HFDC-II
|
| |
|
Data bus: |
16-bit ISA |
|
Size: |
Three-quarter length, full-height card |
|
Hard drive supported: |
Two MFM ST-506/412 drives |
|
Floppy drives supported: |
Two 360KB, 720KB, 1.2MB, or 1.44MB drives |
|
CONNECTIONS | |
|
Function |
Location |
|
4-pin connector - drive active LED |
J1 |
|
20-pin data cable connector - drive 1 |
J2 |
|
20-pin data cable connector - drive 0 |
J3 |
|
34-pin control cable connector - hard drive |
J4 |
|
34-pin control cable connector - floppy drive |
J5 |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
|
LED always "on" when system on |
W1/1 |
open | |
|
LED "on" only when drive is being accessed |
W1/1 |
closed | |
| » |
Four byte ECC enabled |
W1/2 |
open |
|
Reserved - do not use |
W1/2 |
closed | |
|
Cache enabled |
W1/3 |
open | |
|
Cache disabled |
W1/3 |
closed | |
|
Interleave ratio is 1:1 |
W1/4 |
open | |
|
Maximum interleave ratio is 1:3 |
W1/4 |
closed | |
|
Floppy drive primary address is 3F2-3F7h |
W2 |
open | |
|
Floppy drive secondary address is 372-377h |
W2 |
closed | |
|
Note: Close W1/4 when using disks formatted under the WD1003-WAH controller. | |||
|
USER CONFIGURABLE SETTINGS CONTINUED | ||
|
Function |
Location |
Setting |
|
Hard drive primary address is 1F0-1F7h |
W3 |
open |
|
Hard drive secondary address is 170-177h |
W3 |
closed |
|
Floppy drive single speed enabled |
W4 |
open |
|
Floppy drive dual speed enabled |
W4 |
closed |