HwMuseum | Index

ALPHA DESIGN

AD-102V

Data bus:

16-bit ISA

Size:

Three-quarter length, Full-height card

Hard drive supported:

Two IDE(AT) interface drives

Floppy drives supported:

360KB, 720KB, 1.2MB, 1.44MB

CONNECTIONS

Function

Location

34-pin control cable connector - floppy drive

J1

20-pin data cable connector - drive 1

J3

20-pin data cable connector - drive 0

J4

34-pin control cable connector - hard drive

J5

4-pin connector - drive active LED

J6

USER CONFIGURABLE SETTINGS

Function

Location

Setting

»

Controller is incompatible with WD1003-WA2

W2

open

 

Controller is compatible with WD1003-WA2

W2

closed

»

Hard drives in latched mode

W3

open

 

Hard drives in non-latched mode

W3

closed

»

Caching enabled

W4

open

 

Caching disabled

W4

closed

USER CONFIGURABLE SETTINGS(CONTINUED)

Function

Location

Setting

»

4-byte ECC enabled

W5

open

 

7-byte ECC enabled

W5

closed

»

Hard drive primary address select

W6

open

 

Hard drive alternate address select

W6

closed

»

Floppy drive interface primary address select

W7

open

 

Floppy drive interface alternate address select

W7

closed

»

Factory configured - do not alter

W8

N/A

»

Single speed floppy drive supported

W17

open

 

Dual speed floppy drive supported

W17

closed

»

Mounting bracket not grounded

W18

open

 

Mounting bracket grounded

W18

closed