ACCULOGIC, INC.
SIDE-3/ PLUS
|
| |
|
Data bus: |
16-bit, ISA |
|
Size: |
Half-length, half-height card |
|
Hard drives supported: |
Two IDE(AT) drives |
|
Floppy drives supported: |
Two 360KB, 720KB, 1.2MB, 1.44MB or 2.88MB |
|
CONNECTIONS | |
|
Function |
Location |
|
4-pin connector-Drive Active LED |
J1 |
|
40-pin AT Interface (IDE) connector |
J2 |
|
34-pin control cable connector-floppy drive |
J3 |
|
BIOS ADDRESS | |||
|
Address |
Jumper JP12 |
Jumper JP13 | |
| » |
C800h |
open |
open |
|
CC00h |
open |
closed | |
|
D800h |
closed |
open | |
|
DC00h |
closed |
closed | |
|
USER CONFIGURABLE SETTINGS | |||
|
Function |
Location |
Setting | |
| » |
Floppy drive port address is 3F0-3F7h |
JP6 |
open |
|
Floppy drive port address is 370-377h |
JP6 |
closed | |
| » |
Hard drive port address is 1F0-1F7h |
JP7 |
open |
|
Hard drive port address is 170-177h |
JP7 |
closed | |
| » |
Single speed floppy drives supported |
JP8 |
open |
|
Dual speed floppy drives supported |
JP8 |
closed | |
| » |
Floppy drive precompensation is 125ns |
JP9 |
open |
|
Floppy drive precompensation is 187ns |
JP9 |
closed | |
| » |
I/O Channel Ready signal disabled |
JP10 |
open |
|
I/O Channel Ready signal enabled |
JP10 |
closed | |
| » |
BIOS enabled |
JP11 |
open |
|
BIOS disabled |
JP11 |
closed | |
| » |
2.88MB drives not supported on A: |
JP14 |
open |
|
2.88MB drives supported on A: |
JP14 |
closed | |
| » |
2.88MB drives not supported on B: |
JP15 |
open |
|
2.88MB drives supported on B: |
JP15 |
closed | |
|
IRQ14 STATUS | |||
|
Function |
Jumper JP1 |
Jumper JP2 | |
| » |
IRQ14 normal |
closed |
open |
|
IRQ14 delayed until ACTIVE- signal is removed |
open |
closed | |
|
MISCELLANEOUS TECHNICAL NOTES |
|
This Controller has no on-board software. |